Homeautomation - ALL4590 kalibrieren - ALL4590 calibration ALL4590
Geschrieben von on 01 August 2014 04:37
|
|
1. Nulloffset einstellen: Bei den 3 Sensoren, Mathematikfunktionen einschalten und ADD1 enstprechend setzen, 2. Skalierung einstellen: Definierten kosntanten Strom durch die Klemmen schicken, z.b. Heizlüfter o.ä. Wichtig: Last nicht zu klein, 8 A sollten es schon sein. 3. Fertig !
1. Setting up the Zero-offset. enalbe the Math-functions and set ADD1 that 0.00 is shown (Power may not go through the clip yet). 2. Seting up Scaling. defined constant Power should pass through the clips, power on a computer for example. Important: The consumed Power should be atleast 8A. 3. Done! | |
|